Univers by FTE U3500 Guía de instalación descargar pdf (Pagina 11)

v.3500.1.6

Connecting to Ground and Power

Black Wire - Ground

• With the vehicle’s engine OFF, attach the Black Wire directly to a chassis ground point

or to a ground line (chassis ground) by splicing directly to a ground lead or by using a wire

tap (recommended).

Red Wire - Continuous Power

• With the vehicle’s engine OFF, use the voltmeter to locate a 12-volt BATTERY lead and attach

the Red Wire by splicing directly to the lead or by using a wire tap (recommended). If attaching

to a fused lead or using an inline fuse (not necessary), verify that it is at least 5 amps.

• Be careful not to confuse a “Retained Accessory Power (RAP)” line with a true

Continuous Power line (12 volt, always ON line).

• To determine a true Continuous Power source:

1) Ensure the Driver Door is OPEN

2) Select a wire

3) With vehicle’s engine OFF, use a voltmeter to measure the DC voltage on the wire.

It should show 12 VDC or higher.

Note: Please ensure that the Driver

Door is OPEN during the ENTIRE

installation process.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Sin comentarios

Univers by FTE U3500 Guía de instalación Pagina 11